Inhaltsverzeichnis
Werbung
BACK PANEL / RÜCKSEITE / PANNEAU ARRIÈRE / PANEL POSTERIOR / PANEL TYLNY / PANNELLO
POSTERIORE
MODE SELECTION / MODUS AUSWÄHLEN / SÉLECTION DE MODE / SELECCIÓN DEL MODO / WYBÓR
TRYBU / SELEZIONE DELLE MODALITÀ
EN
NOTE
When the projector is properly connected to the mains, the following information appears successively in the display during the startup process:
"Software Update, Please Wait..." (for service purposes only), the software version "Software V1.xx" and "WELCOME TO cameo". After this operation,
the projector is ready for use and changes back to the mode that was previously selected.
STATIC COLOUR
Press the "MODE" button to select the Static Colour Mode. "C000", then press the "ENTER" button to choose one of the static colours using the "UP"
and "DOWN" buttons. The "C1" represents Red, "C2" = Green, "C3" = Blue and "CF" = strobe. The two digits after it are the brightness 00 to 99 or in
"CF" they are the strobe speed. Examples: If you set C1, C2 and C3 to zero, the Tri Par will have no LEDs on (blackout). If you set C1 to 99 and C2 and
C3 to zero, the Tri Par will be 100% Red.
RED
00 - 99 beam level adjustable.
COLOUR JUMPING MODE
Press the mode button to select the Colour Change programme. The unit will then run in Colour change mode. Press the up and down buttons to
select the colour change speed from 0-99.
GREEN
00 - 99 beam level adjustable.
BLUE
00 - 99 beam level adjustable.
STROBE
00 - 99 speed adjustable.
13
Werbung
Inhaltsverzeichnis
