Assembly; Before Startup - Kärcher BDP 50/1500 Bedienungsanleitung

Assembly

1
2
1 Nut
2 Disc
3 Handle
4 Appliance base
5 Hexagonal screw
6 Female connector control line
7 Male connector control line
Unpack the appliance.
Remove the cable ties from the bottom
end of the handle.
Note
Ensure that the toothed wheel does not fall
out of the opening.
Hold the handle over the appliance base
upright and with the cable hook to the
back.
Insert the bottom end of the handle be-
tween the two tabs of the appliance
base.
Align the borings.
Connect the handle and the appliance
base using the 3 enclosed screws, 6
washers and 3 nuts as shown in the illus-
tration above.
Tighten the screws using the enclosed
open end wrench.
Insert the plug of the control line into the
female connector of the control line.
14
English
3 4 2 5
6
7

Before Startup

Inserting a filter bag
Disconnect the mains plug from the
socket.
Pull the lever for level adjustment and
bring the handle in a vertical position.
Tilt the appliance backward and store it
on the handle.
1
1 Filter bag
2 Cover
3 Connection neck, vacuum apron
Slide the cover downward/to the rear and
remove it.
Insert the filter bag into the appliance
and place over the connection neck of
the vacuum apron.
Replace cover.
Attach the pad
Caution
Risk of damage!
Do not store the appliance with inserted pad.
Always remove the pad after every use.
Disconnect the mains plug from the
socket.
Pull the lever for level adjustment and
bring the handle in a vertical position.
Tilt the appliance backward and store it
on the handle.
2 3