Replacing The Illumination Lamp; Door Open Alert; Product Features; The Ice Storage Area - Beko GN162340XBN Bedienungsanleitung

Food
Fresh meat, poultry, fish, sausage etc. Cooked foods
Ready to serve foods, packaged products, canned foods and
pickles
Beverages, bottles, spices and snacks

8.1 Replacing the Illumination Lamp

Call the Authorized Service when the Bulb/
LED used for lighting in your refrigerator
will be replaced.
Lamp(s) used in this appliance cannot be
used for house lighting. Intended use of
this lamp is to help the user place food into
the refrigerator / freezer safely and com-
fortably.
9

Product Features

9.1

The ice storage area

Ice/Water Taking
Select the related option by using the dis-
play in order to take water (
( ) / crushed ice (
trigger on the water dispenser in order to
take water/ice. When you switch between
ice cube ( ) / crushed ice (
ice type remaining from the previous selec-
tion can be given in the first few takings.
) / ice cube
). Push forward the
) options,
Location
If available, zero degree (for breakfast food) compart-
ment
Top shelves or door shelf
Door Shelf

8.2 Door Open Alert

An audible alert will be heard if the
product's door remains open for 1 minute.
The audible alert will stop when you close
the cabinet door or press any button on the
display (if available).
• In order to take ice from ice / water dis-
penser for the first time, you have to wait
approximately for 12 hours. In the event
that there is not sufficient ice in the ice
container, you cannot take ice from the
dispenser.
• Do not consume the ice cubes (3-4 litres)
after first running.
• If a power failure or temporary malfunc-
tion arises while the product is running,
ices may melt a little and refreeze. In this
case, ices may stick to each other. In the
event that the power failure or the mal-
function goes on, ices may melt and
cause a water leakage. When such a
problem exists, clean the ice container by
pouring the ices left in the ice container.
WARNING
The water system of the product
should only be connected to cold
water line. It should not be con-
nected to the hot water line.
• Water may not be taken during the first
operation of the product. This is because
there is air in the system. You have to dis-
charge the air in the system. For this pur-
pose, press on the trigger of the dis-
penser for 1-2 minutes until the water
EN / 22