testo 54 Serie Bedienungsanleitung Seite 49

5 5 . . 8 8 S S e e t t t t i i n n g g D D e e f f a a u u l l t t V V a a l l u u e e s s
The user has the possibility to set all pa-
rameters back to their default values by
using the parameter
rameter must be programmed
with the value
ceed to the next parameter using the keys,
Menu <–> Selection
press the
5 5 . . 9 9 E E n n d d o o f f S S e e t t u u p p y y e e s s / / n n o o ? ?
Menu <–> Selection
press the
5 5 . . 1 1 0 0 C C h h e e c c k k / / A A l l t t e e r r P P a a r r a a m m e e t t e e r r s s
Menu <–> Selection
. This pa-
If you then pro-
Select digit
Set digit
keys to accept the selection
Parameter will be stored-> Operation
Check/alter Parameters
keys to accept the selection
Checking the individual menu items
• after every 2 seconds the menu changes
to Selection
• If the setting is as desired, then switch to the next menu with
key , otherwise, start the set-up again.
then all parameters are reset to their de-
fault values. It is not necessary to finish
the programming; a new programming
cycle can take place immediately.
➱
5.11, 28
Page 23