Menu Selection - testo 54 Serie Bedienungsanleitung

5 5 . . 2 2 I I n n p p u u t t P P a a r r a a m m e e t t e e r r s s f f o o r r I I n n s s t t a a n n t t a a n n e e o o u u s s
v v a a l l u u e e
All set-ups related to the input signal and
the corresponding displayed value are
5 5 . . 2 2 . . 1 1 S S e e l l e e c c t t r r a a n n g g e e f f o o r r t t h h e e i i n n p p u u t t s s i i g g n n a a l l
Menu <–> Selection
press the
5 5 . . 3 3 S S e e l l e e c c t t t t h h e e i i n n p p u u t t s s i i g g n n a a l l
Menu <–> Selection
press the
5 5 . . 3 3 . . 1 1 T T h h e e r r m m o o c c o o u u p p l l e e s s
5 5 . . 3 3 . . 1 1 . . 1 1 S S e e l l e e c c t t T T y y p p e e o o f f T T h h e e r r m m o o c c o o u u p p l l e e s s
Menu <–> Selection
press the
Page 12
➱
5.3.2, Resistance measurement
(Pt100, Pt1000, 0 ... 400 Ω and 0 ... 4000 Ω)
➱
5.3.2, Input range 0 ... 100 mV
➱
5.3.4, Input range –100 ... 100 mV
➱
5.3.1, Thermocouples
keys to accept the selection, based on the sensor being used
keys to accept the selection
Type B
Type E
Type J
Type K
Type N
Type R
Type S
Type T
key to accept the selection
carried out here. The displayed value
is displayed from the input signal via the
scaling slope.
16
12
For the thermocouples
specified here, scaling
slopes with 24 pairs of
values are stored in the
unit. Intermediate input
values between the
stored pairs of values are
linearly interpolated.
14
17