Parameter 4: Call Button Enabling; Parameter 5: Button Enabling To Call Switchboard; Controls And Displays For Configuration; Reading/Configuration Sequence - urmet 2Voice 1083/38 Anleitung

the electric lock may only be activated by pressing the door opening button on the calling station when an
audio conversation has been established or when after having received a call or auto-on function either a
video connection has been established.
In "Free" mode, instead, the indoor station door opener button will only open the door unit electrical lock
only if the door unit is configured as main or the user belongs to the same door unit riser. This riser is defined
by the secondary door unit ID setting. This function is typically used for secondary stations.
The above applies to the vehicle and pedestrian gate electrical lock.

5.1.4. PARAMETER 4: call button enabling

This parameter can be changed to enable call buttons (2) and (7) present on the front part of the door unit.
Specifically, the buttons can be enabled on the call button only (7), on both buttons or on no button.

5.1.5. PARAMETER 5: button enabling to call switchboard

If the door unit was configured as main unit (by means of parameter 1), then call buttons (2) and (7) can be
enabled to call the switchboard.
If the buttons are enabled to call the switchboard (parameter 5 enabled) if will not be possible to
configure the call button enabling function (parameter 4).

5.2. CONTROLS AND DISPLAYS FOR CONFIGURATION

The configuration and the respective set values are displayed by means of:
• LED (1) for programming, as shown below:
LED reference
LED colour
Symbol on front
• LED (4):
• BUTTON (7):
• PROGRAM button (10): button for starting the configuration.
See the "Structure" chapter for the location of these components on the door unit.

5.3. READING/CONFIGURATION SEQUENCE

Each parameter is associated with a colour of the LEDs (1) for programming and the set value is indicated
by the LED (4) as follows:
• LED (4): OFF
• LED (4): ON STEADY
• LED (4): ON BLINKING
The steps for reading or configuring the device are shown below:
1. Press the PROGRAM button (10) briefly (less than 2s): the LEDs (1) will blink on the door unit [A: red, B:
orange, C: red] to indicate that the device is in programming mode.
2. Press the BUTTON (7) again briefly to select the parameter to be configured which can be identified by
the LEDs associated with it according to the table shown in the following chapter.
3. Select the parameter and hold the BUTTON (7) pressed for longer (from 5 to 10 seconds) to set the
parameter as indicated visually by the LEDs (4).
4. Press the PROGRAM button (10) briefly or wait for the timeout after 10 minutes to end configuration
mode.
12
Red or Green
LED for displaying the set parameter value;
button for changing and/or confirming the parameter
A
Orange
B
Red or Green
DS1083-117B
C