Specifications - Makita DCS551 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Button
1-2. Red indicator
1-3. Battery cartridge
2-1. Indicator lamps
2-2. Check button
3-1. Switch trigger
3-2. Lock-off lever
4-1. Battery indicator
5-1. Mode indicator
6-1. Lever
7-1. Alignment line

SPECIFICATIONS

Max. Cutting depth
Overall length (with BL1830)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in mild steel.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
7-2. Cutting line
7-3. Base
8-1. Lamp
9-1. Shaft lock
9-2. Hex wrench
10-1. Hex bolt
10-2. Outer flange
10-3. Saw blade
10-4. Inner flange
10-5. Cup washer
11-1. Hex wrench
Model
Blade diameter
No load speed
Rated voltage
Net weight
noise level determined
) : 78 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,M
2
ENE022-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG905-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG900-1
For European countries only
sum) EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Cordless Metal Cutter
Model No./ Type: DCS551
Conforms to the following European Directives:
ENG901-1
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3
12-1. Hook
12-2. Screw
13-1. Front grip
13-2. Rear handle
13-3. Base
14-1. Cutting line
14-2. Base
14-3. Sight grooves
15-1. Clamp screw
15-2. Rip fence (Guide rule)
DCS551
136 mm - 150 mm
57.5 mm (with 150 mm diameter)
-1
3,900 min
332 mm
D.C. 18 V
2.9 kg
ENH101-18