Installation; Installation Example; Maintenance; Spare Parts - Nederman 10500133 Bedienungsanleitung

4 Installation

NOTE!
For storing the welding gun, see
the following list.
1 Welding ground clamp.
2 Earth cable.
3 Holder for welding pistol.
The Welding and Grinding table should be located with
consideration for easy handling of the collected dust
and for convenience of service and maintenance, see
Figure 3.
The Welding and Grinding table is usually installed on
a reinforced concrete foundation. When calculating
for foundation or supporting structure it should be
taken into consideration the total weight of the table
including the collected contamination. The Welding
and Grinding table is to be securely anchored to the
foundation.
Connect the outlet (outlets) to a duct system, see
tion 4.1 Installation example.

4.1 Installation example

See Figure 3 and the following list.
1 Gables possible to fold for long working objects.
2 Regulating damper.
3 Motor damper.
4 Regulating damper.
5 Motor damper.
6 Fan Inverter.
7 After cleaning damper.
8 Filtermax DF 80.
9 NCF Fan.
10 Dust drawer.
11 Welding and Grinding table, width 1355.
12 Welding and Grinding table, width 2000.

5 Maintenance

WARNING! Risk of personal injury.
Use protective goggles, breathing mask and
gloves when doing service work, specially
when emptying the dust box.
Check the following points at least twice a year or
when necessary.
• Empty the dust box. Do not let it overfill. Disposal of
dust should be in accordance with local regulations.
• Check that the outlet connection not is blocked.
Welding and Grinding table
• Check that the outlet connection to the duct or mo-
tor damper is tight and secured.

6 Spare Parts

Figure 2 and
Table screen, see
Contact your nearest authorized distributor or
Nederman for advice on technical service or
if you require help with spare parts. See also
www.nederman.com.

6.1 Ordering spare parts

When ordering spare parts always state the following:
• The part number and control number (see the
product identification plate).
• Detail number and name of the spare part (see
www.nederman.com/en/service/spare-part-
Sec-
search).
• Quantity of the parts required.

7 Recycling

The product has been designed for component mater-
ials to be recycled. Different material types must be
handled according to relevant local regulations. Con-
tact the distributor or Nederman if uncertainties arise
when scrapping the product at the end of its service
life.
Figure 4.
CAUTION! Risk of equipment damage
Use only Nederman original spare parts and ac-
cessories.
EN
9