Cleaning And Maintenance - Concept RK-3120 Bedienungsanleitung

EN
EN
CAUTION
out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (6), open the lid (1), and fi ll the appliance with cold water within the permitted
maximum only. If the water level in the kettle is under the recommended minimum, the kettle will keep overheating
and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn off automatically
2. Place the kettle on the base (6); electric contacts will get connected automatically. Thanks to the central connector
design, the kettle can turn around 360° and be put on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (5).
A control light on the switch signals the kettle is in operation. The kettle lid (1) must be properly closed when water is
being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed. Hot steam could scald you!
5. After the boiling point has been reached, the kettle will turn off automatically, and the operating light will go out.
Water heating can be terminated prematurely by moving the switch (5) to the off position.
6. Remove the kettle from the base (6) and use the hot water.
7. If you want to reheat the water you have just fi nished boiling, wait for approximately 30 seconds before reactivating
the switch (5).
Note: It is not a sign of a defect when a small amount of water droplets appear on the kettle base (6). It is a small
amount of condensed steam, which deactivates the kettle thermostat.

CLEANING AND MAINTENANCE

Warning!
Never clean the appliance under running water, never flush it and never immerse
the appliance into water!
Scale removal
Note:
service life of the appliance materially.
RK3030 RK 3120 19 19