Klarstein VINSIDER 35D Bedienungsanleitung Seite 32

EN
32
• You can touch SET mark to set the internal temperature for each zone. The degrees
indicators will appear in the display window marked
for LOWER ZONE.
• When you touch the SET mark for the first time the LED readouts will show the
original temperature sets previously (the preset temperature at the factory for UPPER
ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC / 60ºF).
• Touch the SET mark once. The left LED indicator for UPPER ZONE will flash. Then
touch the UP or DOWN marks to set the desired temperature.
• When you touch the SET mark again, the right LED indicator for LOWER ZONE will
flash. Then proceed to touch the UP or DOWN marks to set the desired temperature
for the LOWER ZONE.
• The temperature will increase 1 °C or 1ºF if you touch the UP mark once, or the
temperature will decrease 1 °C or 1ºF if you touch the DOWN mark once.
• To view the "set" temperature in either zone at any time, touch the UP or DOWN
mark, the "set" temperature will temporarily "flash" in the LED display for 5
seconds. You can touch the SET mark to view the temperature setting from one zone
to the second zone.
Temperature Display
During normal operation, the temperature display on the control panel shows the
temperature inside the appliance. The temperature display will flash if:
• A different temperature is being set,
• The temperature in the zone deviates by more than 5 °C from the set temperature.
The temperature display flashing ensures that the temperature can not rise or fall
un-noticed and impair the wine.
Dynamic Cooling/Silent Mode
This Dynamic Cooling enables the relative humidity you would like to use the unit to store
wine long term, In the Dynamic Cooling, the interior fan will cycle on and off to circulate
the inside air. To switch off the Dy- namic Cooling, touching and holding the UP mark for
at least 5 seconds and you can hear "B B B" three sounds and the unit will work in Silent
mode.
To switch on the Dynamic Cooling, touching and holding the LOWER mark for at least
5 seconds and you can hear "B B B B B" five sounds and the unit will work in Dynamic
Cooling mode.
for UPPER ZONE and