ASROCK 775XFire-RAID Bedienungsanleitung Seite 24

All manuals and user guides at all-guides.com
SLI/XFIRE Power Connector
(4-pin SLI/XFIRE_POWER1)
(see p.2 No. 31)
Game Port Header
(15-pin GAME1)
(see p.2 No. 23)
2.10 2.10 2.10 Serial A Serial A Serial A Serial AT T T T T A (SA A (SA A (SA A (SAT T T T T A) Hard Disks Installation
2.10 2.10 Serial A A (SA
This motherboard adopts Intel ICH6R south bridge chipset that supports Serial ATA
(SATA) hard disks and RAID (RAID 0, RAID 1, and Intel Matrix Storage) functions.
You may install SATA hard disks on this motherboard for internal storage devices.
This section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
It is not recommended to switch the "Configure SATA as" setting between
AHCI, RAID, and IDE mode after OS installation.
2 4 2 4 2 4
2 4 2 4
ASRock 775XFire-RAID Motherboard
It is not necessary to use this
connector, but please connect it
with a hard disk power connecor
when two graphics cards are
SLI/XFIRE_POWER1
plugged to this motherboard at
the same time.
Connect a Game cable to this
header if the Game port bracket
is installed.
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation