Package List; Assembly Guide - Eleglide Citycrosser Bedienungsanleitung

5. Package List

Eleglide Pedelec x 1
Charger x 1
Spoke Reflector x 2
Front Mudguard x 1
Key x 2

6. Assembly Guide

Step 1 Install The Handlebar
A) Take out the bike and make it stand up.
B) Open the stem clamp by loosing the screws on it.
C) Place the handlebar in the right position and make sure the clamp is in the middle of the bar.
D) Close the clamp and secure the handlebar by tightening the screws.
Step 2 Install The Front Wheel
A) Put the bike upside down.
B) Remove the temporary protected bar by loosening the nuts on it.
C) Loosen the nuts on the front wheel and insert the front wheel between the fork blades so that the
axle can seat firmly at the fork dropouts (the slots at the tip of the fork blades).
D) Tighten the nuts to secure the front wheel.
User Manual x 1
Power Cord x 1
Rear Reflector x 1
Rear Mudguard x 1
Saddle x 1
Pedal x 2
Front Light x 1
Display x 1
Front Rack x 1
Tool Kit x 1
EN
5