Operational Safety - Beko RFNE448E35W Bedienungsanleitung

Safety and environment instructions
Do not cover or block the ventilation
openings. Otherwise, power
consumption increases and your
product may get damaged.
Product must not be connected to
supply systems such as solar power
supplies. Otherwise, your product
may get damaged due to sudden
voltage changes!
The more refrigerant a refrigerator
contains, the larger the installation
location must be. If the installation
location is too small, flammable
refrigerant and air mixture will
accumulate in cases of refrigerant
leakage in cooling system. The
required space for each 8 gr of
refrigerant is 1 m3 minimum. The
amount of refrigerant in your
product is indicated on the Type
Label.
Product must not be installed in
places exposed to direct sunlight
and it must be kept away from heat
sources such as hobs, radiators, etc.
If it is inevitable to install the product
close to a heat source, a suitable insu-
lation plate must be used in between
and the following minimum distances
must be kept to the heat source:
- Minimum 30 cm away from heat
sources such as hobs, ovens, heater
units or stoves,
- Minimum 5 cm away from electric
ovens.
Protection class of your product
is Type I. Plug the product in a
grounded socket that conforms
the voltage, current and frequency
values stated on the type label of
the product. The socket must be
equipped with a 10 A – 16 A circuit
breaker. Our company shall not
be liable for any damages that
will arise when the product is used
without grounding and electrical
connection in accordance with the
local and national regulations.
Product must not be plugged in
during installation. Otherwise, there
is the risk of electric shock and injury!
Do not plug the product in sockets
that are loose, dislocated, broken,
dirty, greasy or bear the risk of
getting in contact with water.
Route the power cable and hoses (if
any) of the product in a way that they
do not cause risk of tripping over.
Exposing the live parts or power cable
to humidity may cause short circuit.
Therefore, do not install the product
in places such as garages or laundry
rooms where humidity is high or
water may splash. If the refrigerator
gets wet with water, unplug it and
call the authorised service agent.
Never connect your refrigerator to
energy saving devices. Such systems
are harmful to your product.
A

1.6- Operational safety

Never use chemical solvents on
the product. There is the risk of
explosion!
If the product malfunctions, unplug it
and do not operate until it is repaired
by the authorised service agent.
There is the risk of electric shock!
Do not place flame sources (lit
candles, cigarettes, etc.) on or close
to the product.
Do not climb on the product. There is
the risk of falling and getting injured!
Do not damage the pipes of the
cooling system with sharp or
penetrating objects. The refrigerant
that might come out when the
refrigerant pipes, pipe extensions
6 / 22 EN
Refrigerator/User Manual