Therabody RecoveryAir PRO Gebrauchsanweisung Seite 4

RecoveryAir PRO Compression Pants
EN
Instructions For Use
Before first use, read the RecoveryAir PRO User Manual for instructions on operating the full
pneumatic compression system and for the full Safety Warnings and Precautions.
Wearing Instructions
Use the RecoveryAir PRO Compression Pants in a supine position (lying face up on a bed or couch). Always wear light, comfortable clothing under the
RecoveryAir PRO Compression Pants (sweatpants or leggings and socks, free of buttons or zippers that may rub against the skin) to absorb perspiration, prevent
irritation, and keep your RecoveryAir PRO Compression Pants clean. Do not wear your RecoveryAir PRO Compression Pants over bare skin.
1. Position the RecoveryAir PRO pump so that you can reach it easily from the
massage position. Lay the RecoveryAir PRO Compression Pants on the bed or
couch, with the logo side facing up.
2. Open the zippers on both sides of your RecoveryAir PRO Compression Pants
halfway. Get into the Pants and close the zippers all the way to the top.
3. To increase contact with your abdomen, you may place a pillow or bolster under
your knees.
Note: The RecoveryAir PRO Compression Pants should not fit tightly. A pair of
Expanders are available for an increase in width.
Using the Optional Foot Straps
You may use the Foot Straps to form a customized "boot" for your foot (see Figure 1).
1. Adjust the lengthwise straps at the tension buckle. Located at the low section of the
legs, pull the open side of the strap to raise the boot to an angle that is comfortable.
To lower the boot angle back to parallel, loosen the strap at the buckle.
2. After a few inflation cycles you may adjust the angle of the boots by releasing the
buckle or pulling on the strap.
3. When the massage is complete, leave the straps in place for your next massage.
1
Figure 1