Blaupunkt BLUEBOT PRECISION PLUS Bedienungsanleitung Seite 22

MAINTENANCE
BATTERY
· The robot is furnished with high-performance lithium-ion batteries.
· To maintain battery performance, please keep the robot charged in daily use
· If the machine is left unused for any length of time, please shut down and
keep it properly.
· Charge it at least every three months to avoid damaging batteries due to
excessive discharge.
FIRMWARE UPGRADE
· Upgrade rmware using the Bluebot app. If new rmware is detected, upgrade
it according to the report.
· The battery level should be ≥ 50% during rmware upgrade, so if needed the
machine should be placed on the charging station to charge before the rmware
upgrade takes place.
SYSTEM RESET
· Press the 'reset key' on the side of the robot for at least 5 seconds. Make sure
that you place the robot back on its charging station.
· The current map and timing will be lost, WIFI and personalised settings will be
reserved after reset.
FAULT STATE
If the robot encouters a fault while working, the power indicator blinks quickly
in red, and a voice prompt is generated.
NOTE
• If no operation is peformed beyond 10 minutes, the robot automatically enters in
sleep mode.
• Put the robot back to charging in fault state, the clenaing will end.
22
COMPONENT MAINTENANCE
Regular maintenance
To achieve the best cleaning e ect, clean and maintain the robot regulary
according to below table. Determine the frequency of cleaning and
maintenance according to your use habits.
CLEANING
PARTS
FREQUENCY
Filter
Roller brush
Side brush
Roller brush cover
Sensor
Charging pins
Universal wheel
Dust Bag
REPLACEMENT
FREQUENCY
Weekly Every 2 months
Weekly Every 6 to 12 months
Every 3 to 6 months or when it
Monthly
is obviously damaged
Every 3 to 6 months or when
the rubber silicon strip on the
Monthly
roller brush cover is obviously
damaged
Monthly When it is obviously damaged
Monthly -
Monthly -
Replace when the self-empty
station prompts it is full of dust
-
or replace it once after using
it 10 times.