ADURO 9 Lux-Serie Bedienungsanleitung Seite 34

Aduro 9 air, 9.3 Lux, 9.5
Lux, 9 Lux Ceramic, 17 &
17.1 Lux
Aduro 9.7 Lux
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney you should use the rear outlet (this does not apply to
Aduro 9.7 Lux) or a curved flue pipe via the top outlet (or through the room above the combustion chamber
for Aduro 9.7 Lux). After measuring, a hole is made in the chimney in which the pipe sleeve is placed, and
stove mortar is used to seal it in place. The stove is placed in position, and the flue pipe is put in place. A thin
gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude
into the pipe sleeve but must not block the opening in the chimney (see the illustration below). You may
benefit from putting a slim gasket between the flue on the stove and the flue pipe.
The stove can be connected to a chimney to which other heat sources are connected.
The stove leaves the factory with the flue outlet mounted on the top. If you
require the flue outlet on the back, break off the cover plates positioned at the
top of the back of the stove. Exchange the exhaust connector (from the top
outlet) with the cover plate from the rear outlet. Mount the cover plate from
the rear outlet to the top outlet. The top outlet is finished with the plate that
lies in the ashpan. You may benefit from putting a slim gasket between the
flue on the stove and the flue pipe.
Specific for Aduro 9 Lux Ceramic: If you choose to use the smoke outlet at
the back of the stove, it is important to mount the pipes before the stones are
mounted. Remember to place the cover plate correctly.
The stove leaves the factory with the flue outlet mounted on the top. If you
require the flue outlet on the back, use a 90 flue pipe. Use a standard flue
pipe (see illustration below). The top outlet is finished with the plate that lies
in the ashpan. You may benefit from putting a slim gasket between the flue
on the stove and the flue pipe.
34