Maintenance And Cleaning; Warranty; Repair And Service - Opranic V70-Serie Bedienungsanleitung

• The heater is equipped with a protective grill to prevent contact or to prevent large
objects from touching the hot lamp. The unit must not be used without this protective
grill.
• Ensure that there are no flammable materials gathered on or close to the heater.
• The free space to the flammable material in the direction of radiation must be at least 1
meter (3 feet).
• The distance to the floor shall be min 1,8 meter.
• Do not place the heater directly under the electrical socket.
• The cable and plug must not be placed inside the hot radiant area.
• Do not stick anything into the protective grid.
• Do not make use of your heater to light up cigarette or similar materials.
WARNING – TO REDUCE THE RISK OF FIRE
1. Do not place any objects such as furniture, papers, cloths, and curtains closer than 1m
(3 feet) to the front of the heater and keep them away from the sides and rear when the
heater is plugged in.
2. Do not place the heater near a bed because objects such as pillows or blankets can fall
off the bed and be ignited by the heater.
3. Always unplug the heater if it is not being used.
4. Avoid the use of an extension cord because the extension cord may overheat and cause
a risk of fire. However, if you have to use an extension cord, the cord shall be 1,5mm²
(14 AWG) minimum size and rated not less than 10A.
5. Do not operate within 7.6m (25 feet) of inflammable material (gasoline, alcohol etc.)
6. Never block the front grill of the heater.
7. Never attempt to service the heater without disconnecting its power source.
8. DO NOT COVER the heater.

1.3 MAINTENANCE AND CLEANING

• Unplug your heater first.
• Never pull your power cable to unplug your heater
• Unplug power cable
When the unit is used for the first time or after a long period of disuse, smoke or odour may
result from dust or dirt that has collected on the element. This is completely normal and
disappears after a short time. The power supply to the unit must be disconnected during
all service, repair and maintenance work. The unit has no moving parts so the maintenance
requirement is small, but it must be kept clean and free from dust and dirt. If the reflector
is not clean the thermal radiation from the unit will decrease and the heater will become
hotter. A large amount of dirt can cause overheating. The surface of the reflector is
sensitive and must be cleaned with care. If the reflector is dirty it must be cleaned or
replaced by a specialist.
Do not immerse the product into any type of liquid for cleaning purpose. Never use petrol,
solvent or any similar material, which may damage the product

1.4 WARRANTY

The warranty for Opranic PRO series is 2 years. Please read the warranty section for terms
for the warranty.

1.5 REPAIR AND SERVICE

Attention! Only technical services and persons authorized by Opranic may serve, repair and
replace the parts of this heater.
6
EN