MaxPro MPAG650/100 Bedienungsanleitung Seite 9

1. Mount the flange C on the spindle shaft D with the groove forward and turn it until it locks into place and
is securely seated on the spindle.
2. Place the disc on the flange C with the swell forward.
3. Depending on the disc type, screw the flange nut B onto the spindle as shown in the following figures:
- Grinding disc for thick grinding discs, the protruding ring E of the flange nut B must extend into the disc
hole.
Cut-off disc
For thin cut-off discs, the protruding E of the flange nut B must be pointing to the outside.
4.Press and hold down the spindle locking mechanism (2) on the upper side of the device. Tighten the
flange nut B with the hook wrench. Then release the spindle locking mechanism.
5.Check whether the mounted disc is able to freely rotate under the guard.
6.
approximately 30 seconds without applying a load. Pull the plug and check whether the disc is firmly
seated.
Activating/deactivating
9
All manuals and user guides at all-guides.com
Angle Grinder MPAG650/100 User Manual
3
4
5
6
GB