Accessories; Outdoor Use; During Use - MaxPro MPAG650/100 Bedienungsanleitung

ACCESSORIES

Maxpro can assure flawless functioning of the tool only when the correct accessories are used which can
be obtained from your Maxpro dealer

OUTDOOR USE

BEFORE USE
Do not work materials containing asbestos (asbestos is considered carcinogenic)
Use suitable detectors to find hidden utility lines or call the local utility company for assistance (contact
with electric lines can lead to fire or electrical shock; damaging a gas line can result in an explosion;
penetrating a water pipe will cause property damage or an electrical shock)
harmful (contact with or inhalation of the dust may cause allergic reactions and/or respiratory diseases to
the operator or bystanders); wear a dust mask and work with a dust extraction device when connectable
with additives for wood conditioning; wear a dust mask and work with a dust extraction device when
connectable
-related national requirements for the materials you want to work with
country-specific regulations; these regulations are to be observed under all circumstances)
piece in case it does not remain stationary from its own weight

DURING USE

equipment may be affected (if the system impedance of the power supply is lower than 0,104 + j0, 065
Ohm, disturbances are unlikely to occur); if you need further clarification, you may contact your local
power supply authority
the plug;
Never use the tool with a damaged cord
ase of electrical or mechanical malfunction, immediately switch off the tool and disconnect the plug
immediately in order to prevent uncontrolled restarting
AFTER USE
WHEN CONNECTING NEW 3-
the plug
unattended
7
All manuals and user guides at all-guides.com
A A ngle Grinder MPAG650/100 User Manual
-Maxpro accessories observe the instructions of the manufacturer concerned
-hole grinding/cutting discs
supporting walls (slots in supporting walls are subject to
-time voltage drops; under unfavourable power supply conditions, other
SYMBOLS
Read the manual
Warning
making any adjustment or changing any accessory
smaller than M10 x 21 mm
with a triggering current of 30 mA maximum
wood species, minerals and metal may be
(such as oak and beech dust) especially in conjunction
not touch the cord, but immediately disconnect
accidentally pulled out, unlock the on/off switch
the accessory by a lateral force applied against it
in the cord of this tool to the earth terminal of
tool, it must be disposed of safely and not left
GB
Amps)