Preparation For Use, Charging Of The System; Preparations For Charging; Charging With The Ac/Dc Adapter - Westfalia NFQ2800 Bedienungsanleitung

All manuals and user guides at all-guides.com

Preparation for Use, Charging of the System

The internal battery has been pre-charged in the factory and must be
completely charged before the first use to ensure a long service life.
Attention! During periods of non-use the power pack should be recharged
every month to preserve performance and service life. Please note that the
battery discharged over a long period of non-use.

Preparations for Charging

1. Make sure the 15 A fuse (13) is inserted into the provided compartment for
the fuse (3) at the front of the unit is in place. If it is not there, insert the
fuse into the compartment. Replacement fuses are additionally packaged
in the accessory compartment at the back side of the unit.
2. The power pack should be charged after use, or if the control LEDs (7)
light up yellow or red after switching the ON/OFF (2) to ON or before you
plan to use it extensively.
3. While charging the indicator LED (9) lights up. It turns off when the
charging cable is disconnected from the unit.

Charging with the AC/DC Adapter

1. Set the ON/OFF switch (2) to OFF.
2. Connect the AC/DC adapter (12) to the
charging socket (9) of the power pack and to
a wall socket.
The charging
lights up. A full charge can take,
depending on the charging state
of the battery, up to 36 hours.
When the charging indicator LED
turns off, the battery is fully
charged.
3. Unplug the AC adapter from the
power mains now. Use only the
AC adapter supplied with the unit
or an AC adapter recommended
by Westfalia.
Operation
indicator LED
10