Remote Listening To The Messages / Remotely Configuring Your Answering Machine - Silvercrest SDT 1.7 A3 - IAN 279401 Bedienungsanleitung

Remote listening to the messages / Remotely configuring your
answering machine
The answering machine supports a remote listening function. This enables you to listen to your
messages or configure the answering machine when on the move. However, this feature requires
performing the following steps from a telephone with tone dial mode.
Proceed as follows:

Call your device.
The answering machine will answer the call and you will listen to the outgoing message
and a confirmation beep. You can cancel at any time the message playback by pressing
the * button.

Press the * button twice.

You are prompted to enter the remote access security code.

Enter the 3-digit code (default 000).

A confirmation beep will sound.
The following options are available:
0 button: to delete all messages
2 button: to listen to the messages
1 button: skip to previous message
3 button: skip to next message
7 button: delete the current message
4 button: to play the outgoing message
5 button: to record an outgoing message
6 button: to stop recording; exit remote listening
8 button: to switch the answering machine off
9 button: toggles between the outgoing messages; switch the answer machine on*
1
* When the answering machine is switched off, press the * button twice and enter
the remote access security code. This enables you to switch the answering machine
on.
If you frequently listen to your messages remotely, we recommend configuring the
Toll Saver mode. In Toll Saver mode the device will answer the call after 5 rings if
there are no new messages. When there are new messages, incoming calls will be
answered after the second ring. If it takes more than 2 rings, there are no new
messages and you can dial off before the answering machine answers the call and
costs are incurred. This function is described in the "Ans Machine (Answering
machine)" chapter.
SilverCrest SDT 1.7 A3
1
English - 95