Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Therefore, slowly push the table in direction to the belt observing the
required incline. For safety use, the gap between the table edge and the
belt should not be higher than 2 mm.
7. After adjustment, tighten the locking lever (43) again.
Assembling the Sanding Dish Cover (56) and the Sanding Dish Table (64)
(Fig. 6-7)
1. Make sure the motor is
switched off.
2. Mount the sanding dish cover
(56) with the four enclosed
screws (7) and the four flat
washers (12).
3. Mount the sanding dish table
on the sanding dish guard
(71).
4. On both sides of the sanding
dish guard (71) there are two
angular notches. Push both
hooks that are on the inner
side of the table into these
notches. These two hooks
are the centre of rotation for
the table.
5. First
push
horizontally
sanding dish and then verti-
cally upwards. For tightening the sanding dish use both yellow knob
screws (66). Tighten the knob screws into the dish guard through both
guide slots that are situated on the table.
6. Position the sanding table to the required angle to the dish and tighten the
two knob screws.
One accessory is a scale (62). Whenever you intend to make double mitre
section, use the scale. Adjust the required angle and place the rod (63) of the
scale into the groove of the sanding disc.
Operation
the
table
against
the
7+12
56
63
62
66
16
Fig. 6
71
64
Fig. 7
Werbung
Inhaltsverzeichnis
