Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting the Sanding Table (Fig. 1-2)
1. Make sure the motor is switched off.
2. Thread the sanding belt (28) through
the opening in the sanding table (41).
3. Tighten the sanding table with the
compatible screw and washer onto the
screw that sticks out from the housing.
The locking lever (43) is still assembled.
It is spring loaded and can be reposi-
tioned. If you pull out the handle you
can change the position of the handle
without moving the inside thread bar.
Sanding Belt Board (Fig. 3)
The sanding belt board (22) protects the
work piece during sanding.
1. Mount the sanding belt board so that
the board touches the backside of the
sanding belt. To adjust, unscrew both
screws (24).
2. Adjust the board and tighten the screws (24)
again.
For work such as polishing or sanding bent
pieces remove the sanding belt board.
Operation
Opening
14
Fig. 1
43
Fig. 2
Fig. 3
28
41
22
24
Werbung
Inhaltsverzeichnis
