Bosch Deepfield Connect Gebrauchsanweisung, Originalbetriebsanleitung Seite 20

20 | English
If the signal strength is too weak, you must re-
test the signal strength in a different location.
The new location must be at least 50 m from
the original position.
Placing the temperature and air
humidity sensor A near the plant
Place sensor A in a position which is as repre-
sentative of the crop as possible. Please note
that environmental conditions such as sinks,
rivers or shade can influence the measured
results considerably. Even within greenhouses
or priming areas, there are varying local con-
ditions: A location that is as representative of
these conditions as possible should be chosen.
In the app, the tab below refers to sensor A.
▷ If necessary, press the stake provided into
the base plate of sensor A.
▷ Press sensor A into the earth until the base
plate contacts the earth, or secure sensor A
in the immediate vicinity of the plants.
Assembling the transmitter
Positioning specifications for the transmitter
(see figure 7, page 4):
– Above the plants
– Not covered by agricultural film
– Good position for transmission and recep-
tion, e.g. above the crest of a bank
– Protected against damage, such as from
tools or agricultural machinery
– Socket facing downward
The transmitter has 3 eyelets which can be
used to attach it to a suitable place, see figu-
re 6, page 4.
▷ Take the protective cap off the transmit-
ter bracket and push the bracket into the
ground.
▷ Open the clamp, pull the transmitter bracket
out and close the clamp again.
▷ Use the eye at the top to hang the transmit-
ter on the transmitter bracket and push the
safety cap onto the end of the bracket.
▷ Thread a cable tie through the eye at the
bottom and around the transmitter bracket.
NOTE
▶ Risk of damage!
Impacts on the transmitter bracket could
damage the transmitter irreparably.
Remove the transmitter bracket extension
upwards when pushing the transmitter
into the ground using the tool.
Field Monitoring | (17.12.19)
Connecting the temperature and air
humidity sensor A to the transmitter
(Basic product variant)
The connectors used for the connections have
keyways and can therefore only be connected
in the correct alignment.
Lay the cables so that they are protected
against mechanical damage, such as from tools
or agricultural machinery.
▷ Insert the connector of the transmitter
cable into the socket on the transmitter and
tighten the union nut by hand in a clockwise
direction (see figure 4, page 3).
▷ Connect the sensor cable with the Superseal
connector to the transmitter cable.
▷ Seal the unused sensor connector using the
cap supplied.
Position and connect the temperature
and air humidity sensor B
(only for Premium product variants)
(see figures 1–3, page 2)
Sensor B can be attached to the transmitter
bracket using the openings on the side of
the weatherproof casing and the cable ties
supplied.
Sensor B is connected between sensor A and
the transmitter.
Lay the cables so that they are protected
against mechanical damage, such as from tools
or agricultural machinery.
▷ Attach the sensor to the transmitter bracket.
▷ Use the sender cable and the Y cable to
establish a connection between sensor B
and the sender. Then connect sensor A via
the extension cable.
Make sure that the total cable length bet-
ween the transmitter and the last sensor
does not exceed 30 meters (see figure 5,
page 3). Otherwise the transmission of
data is no longer secure.
Bosch.IO GmbH, Deepfield Connect