Switching On The Transmitter; Assembly - Bosch Deepfield Connect Gebrauchsanweisung, Originalbetriebsanleitung

▷ Start the app.
▷ Select "log in".
▷ Enter your login data or select "register".
If you are registering again, you will be shown
the criteria for creating a secure password.
Adding a field and assigning
a monitoring station
You will need the app, an Internet connection
and the transmitter's serial number to register
the device. The serial number is stated on
the back of the transmitter in text and as a
QR code.
▷ Start the app and select "Field management
> Monitoring stations > +" in the main menu.
▷ Follow the instructions on the display and
enter the basic data relating to the field.
▷ Under "Monitoring stations", select "New
monitoring station" and scan the QR code
on the back of the transmitter. Alternatively,
you can also set up the monitoring station
and assign it to the field from the main
menu.
A video tutorial can be found at:
www.deepfield-connect.com/field/
support.html
Creating a new field
Now create a new field and assign the trans-
mitter to this field.
▷ Open the main menu and select "Fields >
Create field".
▷ Follow the instructions on the display: Enter
the basic data for the field, connect the
monitoring station and install the monitoring
station.
Linking the monitoring station to the field
Follow these steps to link a monitoring station
to a field that you have already created in the
app:
▷ Open the main menu and select "Monitoring
stations".
▷ Select the respective monitoring station. In
the next window, under "Assigned to field"
select the respective field.
Bosch.IO GmbH, Deepfield Connect

Switching on the transmitter

The magnet supplied is required to switch
the device on. The status LED displays the
progress.
▷ Hold the magnet against the recess on the
transmitter (see figure 4, page 3).
The LED briefly lights up in red at first. Once
the LED turns green, you can remove the
magnet from the casing. The LED will then
go out.
From the time the transmitter is switched on,
it can take up to 20 minutes before the trans-
mitter is ready for operation and able to send
measured values.
The transmitter cannot be switched off using
the magnet. If required, the transmitter is swit-
ched off by Deepfield Connect over the cellular
network.

Assembly

Testing the cellular network
There must be cellular reception at the planned
location so that the transmitter can transfer
the measured values. You can test the recep-
tion using the ready-to-use transmitter.
The status LED displays the signal strength.
The transmitter transmits values once per hour
regardless of whether sensors are already con-
nected. The signal strength cannot be tested
during this transmission process. This status is
shown by a continuous blue light on the status
LED when the signal strength is being tested.
▷ Briefly hold the magnet against the recess
in the transmitter casing to test the cellular
network.
The status LED can then display the following
statuses:
LED Meaning
Blue, Measured values are being
continuous transferred. Signal strength
testing then takes place
automatically.
Blue, The signal strength is being
flashing tested (max. 3 minutes).
Green Strong signal
Yellow Adequate signal
Red Insufficient signal
English | 19
Field Monitoring | (17.12.19)