Before Initial Start-Up; Inserting Back-Up Battery; Cable Antenna - Silvercrest SURF 600 A1 Bedienungsanleitung

Before initial start-up

Put the device on a sturdy, level surface and do not place any heavy objects on the device. Now plug the
connector of the power cable (9) into a socket, which is always easily accessible. Three horizontal bars
and the "RCC" indicator (15) will light up on the display (11). The device is now waiting for a radio
signal, which will set the correct time automatically. This can take a few minutes.
To ensure you don't have to set the stations and alarm time again after a power cut, you
can use the device with a back-up battery. More information on this can be found in the
following section "Inserting back-up battery".
The actual time is set automatically when the power supply is restored.

Inserting back-up battery

There is a battery compartment for a back-up battery on the bottom of the device. It is possible to insert a
CR2032 lithium battery 3 V (not included in the package contents) so that the stations and alarm times
previously stored are retained in the event of a power cut. Also when the back-up battery is inserted 3
horizontal bars and „RCC" light up on the display (11)after a power cut. Press any button for clock mode.
To insert a back-up battery, follow the steps below:

Use a coin to turn the cover of the battery
compartment anti-clockwise until you are able
to remove it.

Insert a CR2032 lithium battery 3 V into the
battery compartment with the positive terminal
upwards.

Close the battery compartment by putting the
cover back on and using the coin to tighten it
in a clockwise direction.
WARNING! Remove the back-up battery if you intend not to use the device for a longer
period of time.

Cable antenna

There is a cable antenna on the back of the device (10). This is rolled up in the package contents when
delivered. Unwind it to improve the reception quality of the radio and radio clock.
SilverCrest SURF 600 A1
English - 11