Westfalia DIY-12 Bedienungsanleitung Seite 40

DIY-12.book Seite 39 Dienstag, 27. März 2007 3:47 15
DIY-12
10.3 Setting the voltage monitoring
➤ Disarm the alarm system.
➤ Switch the ignition on and off three times.
➤ Switch on the ignition again within eight seconds.
✓ The alarm siren sounds two signals after eight seconds.
✓ You are now in setup mode and can adjust the voltage monitoring.
Setting the time delay
You select one of two settings:
– 8 seconds
– 4 minutes
➤ In voltage monitoring setup mode, press the ON/OFF button.
✓ The alarm system indicates the setting.
– 1 signal tone: 8 seconds time delay (default setting).
– 2 signal tones: 4 minutes time delay.
➤ If you want to change the delay setting, press the ON/OFF button again.
✓ A signal sounds.
Activating and deactivating voltage monitoring
➤ In voltage monitoring setup mode, press the P button.
✓ The alarm system indicates the setting.
– 1 signal tone: voltage monitoring is activated.
– 2 signal tones: voltage monitoring is deactivated (default setting)
➤ If you want to change the setting, press the P button again.
✓ A signal sounds, unless this function has been deactivated.
Programming the alarm system
39