Westfalia DIY-12 Bedienungsanleitung Seite 30

DIY-12.book Seite 29 Dienstag, 27. März 2007 3:47 15
DIY-12
5.2 Remote control elements and displays
No. in
fig. 4, Description
page 2
1 ON/OFF button: arms and disarms the alarm
2 P button: panic mode, search function, configuration
3 LED: flashes when either or both of the buttons are pressed.
5.3 Possible operating states
The alarm system has the following four operating states:
Stand-by
The alarm system is constantly on stand-by as soon as it is installed and
correctly connected. However, it does not trigger the alarm when in stand-
by.
Armed
If the system is armed, it can trigger an alarm. This happens, for example,
if someone starts the vehicle or shakes it. If you wish to drive off, you must
first disarm the alarm system. The system is then in stand-by mode.
Warning triggered
If the shock sensor detects a minor shake, the alarm system emits a warn-
ing. The siren sounds five times.
The alarm system then returns to "armed" status.
Alarm triggered
The alarm sounds for 30 seconds and the status LED flashes quickly.
If the alarm is triggered, you can switch off the alarm and then either
leave the system activated ("armed" status) or deactivate it ("standby").
When you switch off the alarm with the remote control, the system
remains armed.
Technical description
29