Westfalia DIY-12 Bedienungsanleitung Seite 39

DIY-12.book Seite 38 Dienstag, 27. März 2007 3:47 15
Programming the alarm system
➤ Within eight seconds, press any button on the remote control to be
programmed.
✓ The siren sounds a signal for the first remote control.
Note
Program all the remote controls you want to use at the same time.
The siren sounds a confirmation:
– For the second remote control with two tones
– For the third remote control with three tones
– For the fourth remote control with four tones
If you do not press a button on a remote control within eight seconds of
switching off the ignition, programming mode is ended.
✓ Programming is now complete.
10.2 Setting the sensitivity of the shock sensor
The shock sensor is preset at the factory. Its sensitivity is correctly set if it
triggers the alarm in the event of a heavy impact against the vehicle.
➤ Disarm the alarm system.
➤ Within eight seconds, press the ON/OFF button and the P button on the
remote control at the same time.
✓ The alarm siren sounds a signal.
✓ The alarm system is in shock sensor configuration mode.
➤ Press the P button.
✓ The alarm system indicates the set sensitivity level by the number of
signal tones. The shock sensor has eight different sensitivity levels.
➤ Press the P button to switch to the next sensitivity level up.
➤ Hit the windows to check that the sensitivity level is not too high. A signal
sounds when the system would trigger an alarm. Then select a lower
sensitivity level.
➤ Press the ON/OFF button.
✓ This quits adjustment mode. The sensitivity level is saved.
38
DIY-12