Switching Off The Alarm - Westfalia DIY-12 Bedienungsanleitung

DIY-12.book Seite 36 Dienstag, 27. März 2007 3:47 15
Operating the alarm system
9.2 Disarming the alarm system
➤ Press the ON/OFF button on the remote control.
✓ The alarm system is disarmed.
✓ The alarm system sounds two confirmation tones, unless the function has
been disabled.
Note
If the siren sounds four tones and the status LED does not flash,
the alarm was triggered while the system was armed.
Disarming the alarm system without using the remote control
If you have misplaced the remote control or the batteries are empty or the
remote control is damaged, you can deactivate the alarm system as follows.
➤ Switch the ignition on and off four times.
➤ Switch on the ignition again within eight seconds.
✓ The alarm system sounds four confirmation tones, unless the function has
been disabled.
✓ The alarm system is disarmed.
9.3

Switching off the alarm

If an alarm is triggered, you can switch it off as follows:
➤ Press the ON/OFF button on the remote control.
✓ The alarm is switched off, but the system remains armed.
9.4 Using the panic mode and vehicle search function
The alarm system has a panic mode. You can trigger the alarm by remote
control, for example to scare off the assailant if you are attacked. You can
use this function to help you find the vehicle.
➤ Press the P button on the remote control and hold it down for three
seconds.
✓ The siren sounds for 30 seconds.
✓ The vehicle remains operational enabling you to drive away.
36
DIY-12