Installing The Alarm System - Westfalia DIY-12 Bedienungsanleitung

DIY-12.book Seite 30 Dienstag, 27. März 2007 3:47 15

Installing the alarm system

6 Installing the alarm system
Note
If you do not have sufficient technical expertise for installing and
connecting the components in vehicles, you should have a special-
ist install the alarm system for you.
6.1 Installing the compact alarm unit
➤ Select a suitable installation location.
Note
When selecting the installation location, observe the following
instructions:
➤ Install the compact alarm unit:
– In the engine compartment near the battery
– With the main connection cable facing downwards
– Away from strong electrical fields such as the ignition system or central
controller electronics
– Not directly near the exhaust system or where water might splash
➤ Tightly fasten the compact alarm unit using the screws provided.
Note
The compact arm unit should be bolted tightly to the bodywork to
ensure that the shock sensor works properly.
6.2 Installing the status LED
Caution
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Drill a hole with a diameter of 8 mm in the dashboard or in an existing
plastic cover.
➤ Guide the status LED cable through the drill hole and insert the status
LED in the drill hole until it latches into place.
➤ The status LED is secured against slipping out with a small hook.
➤ Lay the cable to the compact alarm unit and insert the plug in the two-pin
connection.
30
DIY-12