Manual Operation; Maintenance, Cleaning, Storing And Transport - Westfalia 81 77 22 Bedienungsanleitung

Manual Operation

For manual operation you have to reposition the float switch at a higher level or to
keep the float switch up by hand. By doing this the water/liquid can be pumped up
completely. An automatic cutoff does not occur.
Do not operate the pump unsupervised during manual operation.
Disconnect the pump from power mains as soon as the water level falls below
7 cm. Otherwise, the pump will run dry long and can be damaged.

Maintenance, Cleaning, Storing and Transport

 Unplug the power plug before undertaking any kind of maintenance work or
before cleaning.
 The pump does not require maintenance apart from occasionally cleaning the
housing and the strainer.
 When opening covers or removing casing parts you may expose live parts.
Capacitors inside the device may still carry voltage even though they have
been disconnected from all voltage sources.
 In case the pump pumped fluids, which leave residue, it should be thoroughly
cleaned after use with clean water. Sand, mud or suspended sediment in the
pumped water can affect its delivery rate.
 To thoroughly clean the turbine
wheel, unscrew the six screws and
take apart the base from the upper
housing. Clean dirt with a brush etc.
Rinse the pump with clear water.
 Never
use
cleaners to clean the pump.
 Keep the suction base (7) free from
dirt and blockages of any kind to
prevent clogging.
 Store the pump in a dry place that is protected from dust, dirt and frost. Make
sure the pump is dry before storing it for long time.
 The pump does not contain any parts serviceable by you. Do not disassemble
the pump and do not try to repair it yourself. Repairs must be done by a
professional only.
 Carry the pump only by the carrying handle (1). Never carry, or lift up the
pump by the power cord.
corrosive or
Using
acidic
17