Inhaltsverzeichnis
Werbung
Intended Use
The submersible sump pump has been designed for pumping clear and dirty
water. It is not intended for delivering salt water, corrosive, easily flammable or
explosive liquids (e.g. petrol, paraffin, thinners, etc.), faeces, oil, heating oil or
foodstuffs. The pump can be used for delivering water, containing floating
organical particles such as leaves, paper, plant scraps or firm particles up to a
diameter of 35 mm.
The submersible sump pump can be used for dry up garages, cellars,
basements, swimming pools, tubs, tanks, springs, wells etc. When immersing
the pump into a well, make sure the diameter of the well is not smaller than
40 x 40 x 50 cm so the float switch (4) can float freely.
The pump is not designed for commercial continuous operation.
The intended use also includes an operation following the operating
instructions. Any use beyond these parameters (different media, applying
force) or any changes (reconstruction, no original accessory) can lead to
serious risks and is regarded as use that is contrary to the intended purpose.
Before first Use
Unpack the submersible sump pump and check all parts for any damage in
transit. Keep packaging materials out of reach of children. There is risk of
suffocation!
Preparation
1. Before each use, check the pump and the power cord for any damages. Do
not use the pump in case of damages.
2. Screw the universal hose adaptor (5) on the water outlet opening (6).
3. Tightly attach or screw on the hose (not included) to be used for pumping off
the water to the hose connection (5) of the hose adaptor. If required, use
Teflon tape for sealing.
4. Set the pump on a flat surface into the water supply you want to pump off.
Make sure that the pump cannot move during operation. Pay attention to the
maximum submersion depth (refer to Technical Data). Always make sure that
the suction opening is not blocked or obstructed during operation. If neces-
sary, place the pump on a brick or similar.
5. When immersing the pump in a very deep pit or well, attach a sufficiently
strong rope (water-proof) or chain to the carrying handle in order to guide the
pump down. Never use the power cord for immersing and lifting up the pump.
Using
15
Werbung
Inhaltsverzeichnis
