Before First Use; Preparation; Using - Westfalia 82 29 37 Bedienungsanleitung

Before first Use

Remove the sanitary pressure test pump out of the packaging and check it for
damage in transit. Keep packaging materials out of reach of children. There is
a risk of suffocation.
Screw the pumping lever (1) on the handle shaft (3).

Preparation

Prior to start using the sanitary pressure test pump, please carefully read and
observe the following instructions:
 Work on tube/pipe systems and pressure vessels as well as on solar
systems may only be carried out by specially trained and approved
personnel.
 Please read the manual carefully before operating the pressure test pump.
The pressure inside the test pump is extreme high. Always make sure that
all pressure connections are tight and connected properly.
 Note that the proper function of the test pump depends on the cleanliness
of the test medium. So only fill clean water, oil or glycol (antifreeze) into the
tank. Fill at least 1.1 litres and a maximum of 11.5 litres into the tank. Turn
down the securing hook (2) to unlock the pumping lever (1).

Using

1. First connect the hose with the ½" hose connection (8) to the system to be
tested.
2. Open the valves or cocks of the test system and use the pumping lever to
fill water or oil into the system. If necessary, fill in large quantities of water
(e.g. for newly installed pipes) with a water hose into the system and then
connect the test pump to build the appropriate pressure.
3. Use the pumping lever (1) and pump until the required pressure is reached.
The red drag pointer moves along the black
pointer of the pressure gauge (6). Read the
pressure that has been reached on the scale.
The pressure gauge has a precision scale with 3
international measuring units (bar, psi and MPa).
Pressure range in bar: 0 – 60 (1 bar resolution)
Pressure range in psi: 0 – 860 (20 psi resolution)
Pressure range in MPa: 0 – 6 (0.1 MPa resolu-
tion)
Operation
9