Siemens SIMATIC FS400 Anleitung Seite 113

About this Instruction Manual
This instruction manual contains information on the proper use and effective applica-
tion of the Light Curtains and Light Grids SIMATIC FS400 3RG7845.
WARNING
All the information contained herein, in particular the safety notes, need to be carefully
observed.
Notes regarding safety and warnings are marked by this symbol
Notes regarding important pieces of information are marked by the symbol
This instruction manual must be stored carefully. It must be available for the entire
operating time.
SIEMENS AG is not liable for damages caused by improper use. Knowledge of
this instruction manual is an element of proper use.
Important note
Safe device operation can only be guaranteed when certified components are used!
The products described herein were developed to take over safety-related functions as
part of a turn key system or machine. A complete safety-related system is usually
equipped with sensors, evaluation units, status controls and incorporates concepts for
safe switch-off procedures. It is the responsibility of the manufacturer of a system or a
machine to ensure its correct overall operation. SIEMENS AG, its local offices and
associated companies (hereafter referred to as "SIEMENS") cannot guarantee for all
features of a turn key system or a machine that was not designed by SIEMENS.
Neither does SIEMENS assume liability for recommendations given in or implied in the
following instruction manual. The following instruction manual shall not be construed as
a new guarantee, warranty or liability claim beyond the general terms and conditions of
SIEMENS.
Copyright © SIEMENS AG 2007 All rights reserved
Reprints and reproduction of this instruction manual as well as communication and
utilization of its content is not permitted without express permission. Noncompliance
will entail compensation for damages. All rights reserved, in particular for the grant of
patents or design registrations.
Technical Support:
Telefon:+49 (0) 180 50 50 222
Internet:www.siemens.com/automation/service&support
Subject to change without prior notice.
Warning
Dangerous electric voltage! Electric voltage can cause elec-
tric shock and burns. Before commencement of work you
therefore need to turn the system/device power off.
.
.
113