Sony LMD-182MD Gebrauchsanweisung Seite 33

Connections
Connecting the Monitor and the
AC adaptor
DC IN connector
Connecting the Power Sources
Connect the supplied AC power cord as illustrated.
Use one of the two AC plug holders (supplied) that
will securely hold the AC plug.
1
Plug the power cord into the AC IN socket on the
bottom of the monitor, then attach the AC plug
holder (supplied) on top of the AC power cord.
AC IN socket
AC plug holder
2
Slide the AC plug holder over the cord until it
locks.
To remove the AC power cord
Pull out AC plug holder by squeezing the left and right
sides.
Note
Use the supplied AC adaptor only for LMD-182MD.
AC power plug
Attaching the Input Adaptor
Attach the input adaptor to the optional input slot after
removing the panel of the slot.
1
Remove the panel of the optional input slot of the
lower side as illustrated.
When the BKM-128WX is installed, remove the
lower and upper panels of the slots.
2
Insert the input adaptor into the slot with the top of
the adaptor facing to left.
Face the top of the
adaptor to left.
3
Tighten the screws.
It is recommended to install the monitor to the monitor
stand (optional) after attaching the input adaptor.
9
(GB)