IKEA BATSKAR Bedienungsanleitung Seite 10

air/saltwater can all cause damage to your appliance.
(A cover may not be sufficient to protect your
appliance in some of these situations).
• Cover the burners with aluminium foil in order to
prevent insects or other debris from collecting in
burner holes.
• If the barbecue is to be stored indoors, the gas
cylinder must be disconnected and left outside.
• The gas cylinder should always be stored outside,
in a dry, well-ventilated area, away from any
sources of heat or ignition. Do not let children
tamper with the cylinder.
• Always inspect the hose for cuts, cracks or
excessive wear before use.
• If the hose is damaged or there is excessive
abrasion or wear or the hose is cut, it must be
replaced with a hose suitable for use with LPG and
meet the national standards for the country of use
and must be as specified by the manufacturer. The
length of the hose shall not exceed 1.5m.
TECHNICAL INFORMATION
This barbecue is designed for outdoor use only
using propane gas. Please read all accompanying
documentation carefully.
TROUBLESHOOTING
PROBLEM
Burner will not light using the
ignition system
Low flame or flashback (fire in
burner tube - a hissing or roaring
noise may be heard)
Gas valve knob difficult to turn
10
Switzerland (CH)
Gas Category: I3+(28-30/37)
Gas Type and Pressure: Propane 29mbar
BBQ Gas Consumption: 1245gm/h
Main Burners Injector Size: 0.95mm
Side Burner Injector Size: 0.85mm
BBQ Heat Input: 3.6kW(main burner) x 4 + 3kW (side
burner) = 17.4kW
Countries Intended for: CH
Changing The Gas Cylinder
Check that the burners are extinguished before
disconnecting the gas cylinder.
Check the seals before connecting a new gas cylinder
to the appliance.
Change the gas cylinder outside and away from
people.
HOW TO REACH US IF YOU NEED OUR SERVICE
Contact your local IKEA store. You will find the address
and phone number in the IKEA catalogue or at www.
IKEA.com.
To ensure that we provide you with the best assistance,
please read carefully the Assembly Instructions and/
or the User Instruction section of this manual before
contacting us.
POSSIBLE CAUSE
LP gas cylinder is empty
Faulty regulator
Obstructions in burner
Obstructions in gas jets or gas
hose
Electrode wire is loose
Electrode or wire is damaged
LP gas cylinder too small
Obstructions in burner
Obstructions in gas jets or gas
Windy conditions
Gas valve jammed
SOLUTION
Replace with full cylinder
Have regulator checked or replace
Clean burner
Clean jets and gas hose
Reconnect wire
Change electrode and wire
Use larger cylinder
Clean burner
Clean jets and gas hose
Use BBQ in a more sheltered
position
Replace gas valve