Werbung
AUTO STORE (AST)
Automatically storing stations
¢ Select a FM band or a AM band with the BAND
key.
— Briefly press the AST key, you will hear a beep.
— The set mutes and display shows AST.
~ You will hear a beep when
it has finished
storing 6 stations.
~ You will hear the station on preset 1.
Sometimes it may not be possible to find six
stations. In this case, the remaining presets
are programmed with 0000 (radio mute). If no
stations are found, the previously stored
stations are maintained.
Clock display
— Press the CLOCK key for at least 2 seconds
(until you hear a beep).
— The display shows the time. After any tuning
operations, the frequency will be displayed
for about 10 seconds.
Setting the clock
— While the display shows the clock time, you
can adjust time setting by pressing a 2-key
combination as follow:
CLOCK+ <4
to adjust hours -
CLOCK+P
to adjust minutes
To switch back to frequency display, press the
CLOCK key for about 2 seconds (until you hear
a beep).
TRAFFIC ANNOUNCEMENTS ON FM
Switch on TA mode (so that Traffic
Announcements have priority)
¢ Select a FM band with BAND key.
* Press the TA key for at least 2 seconds (until
you hear a beep). The display shows'
TA'.
¢ If the tuned station does not enable the
reception
of Traffic Announcements,the
display
shows.
'NO
TA'.
The
radio
automatically searches an appropriate station.
* You will hear the Traffic Announcements
when
broadcast.
* If you play a cassette, the radio will interrupt
cassette
playback
each
time a Traffic
Announcement
is broadcast.
Volume level for Traffic Announcements
if you only want to hear Traffic Announcement.
* Tune to your prefered TA-station.
¢ Adjust the desired volume.
* Briefly press 'MUTE'.
Interrupting a Traffic Announcement
If you do not wish to continue listening to a
particular Traffic Announcement,
you can
interrupt it without switching off the TA mode.
* Briefly press the 'MUTE' to silence the set or,
* Press the TA key for at least 2 seconds (until
you
hear a beep).The set will return to its
previous operating mode.
Switching off TA mode (so that Traffic
Announcements do not have priority) —
* Press the TA key for at least 2 seconds (until you
hear a beep). TA disappears from the display.
— If the TA mode is switched on,search tuning
only selects
stations
which
enable the
reception of Traffic Announcements.
— Ifthe tuned station becomes too weak to
enable the set to provide the RDS traffic
service,you
will hear beeps
repeated
at
intervals.Use search tuning to find another
station.
Werbung
