Siemens 7XV5653-0BA00 Handbuch Seite 93

5.2 Interfaces
Optical Interface
Optical inputs/outputs
Optical connector
Data indications
Wavelength
Injected power
Sensitivity
Optical budget
Maximum range
Minimum baud rate
Maximum baud rate
RS232 Interface
Connection
Maximum baud rate
Minimum baud rate
Maximum cable length
Fault-Signaling Output
Connection
Contact voltage (rated voltage)
Switching power
Switched current
Fault display
Binary Inputs
Connection
Contact voltage
Current consumption (independent of voltage)
Status display
Command Outputs
Connection
Contact voltage (rated voltage)
Accessories, Binary signal transmitter 2-channel 7XV5653-0BA00, Manual
C53000-G9050-C607-2, Edition 03.2020
1 transmitter, 1 receiver
Factory setting: light idle state OFF
Transmitter ST: HFBR 1404
Receiver ST: HFBR 2402S
ST bayonet closure
None
820 nm
-19 dBm, gradient fiberglass, 50 µm/125 µm
-15 dBm, gradient fiberglass, 62.5 µm/125 µm
-6.2 dBm, HCS fiber, 200 µm
-30 dBm
Typically 10 dB (+3 dB system reserve)
3 km with gradient fiberglass, 62.5 µm/125 µm
1200 Bd
115 200 Bd
9-pin D-sub socket
115 kBd
1200 Bd
3 m
Standard relay with 1 break contact; isolated; 2-
pole terminal (Phoenix)
AC/DC 250 V
30 W/30 VA
5 A continuous
LED, red (ERR); continuous if device is not ready
for operation or in case of an error of the internal
power supply.
2-pole terminal (Phoenix), isolated
DC 24 V to 250 V/-15 %, +20 %
Approx. 2.5 mA
1 yellow LED per input (BI-1, BI-2)
Standard relays (K1, K2) with 1 make contact,
isolated, 2-pole terminal (Phoenix)
DC/AC 250 V
Technical Data
5.2 Interfaces
43