Siemens 7XV5653-0BA00 Handbuch Seite 77

NOTE
i
i
Transmission using 2-wire operation was successfully tested with these settings. At higher baud rates,
problems may occur. At lower baud rates, the command S51=xx must be changed as required. The
selected baud rate must be set on both binary-signal transmitters (also see
Formats).
Plugs and Cables for 2-Wire Dedicated Line Operation
Use the supplied cables for normal dial-up operation for the 2-wire dedicated line operation.
²
Insert the cable into the dial-up plug.
²
If TAE boxes with N encoding are used for the connection, the lines must be connected as follows:
Table 3-2
Accessories, Binary signal transmitter 2-channel 7XV5653-0BA00, Manual
C53000-G9050-C607-2, Edition 03.2020
3.2 Binary-Signal Transmission Using the LOGEM928 and LGH28.8D Dedicated Line Modems
Connection for 2-Wire Dedicated Line Operation
TAE-N 1
1
2
Application Examples
2.6 Baud Rates and Data
TAE-N 2
1
2
27