Chronograph: Basic Function - Bauhaus Ronda 5130.D Bedienungsanleitung

Reference time
EN Cal. 5130.D & 5130.B
Alarm time
What is the reference time?
The current time is displayed by means of the hour and minute hand.
Parallel to the current time, the reference time runs in the background: the alarm time
refers itself to this reference time. Thus, resetting the time also requires the identical
correction of the reference time.
If the reference time is not synchronised with the current time, this results in the
alarm signal being emitted at a different time to the set alarm time.
08
28
Ronda_5130.D_bauhaus_aviation.indd 28 Ronda_5130.D_bauhaus_aviation.indd 28
I II
III

B
A
0 4
I II III

B
A
2 3

Medium pressing: (1–2 seconds):
the reference time is moved forwards by
the hour.
Long pressing (longer than 2 seconds):
the reference time is moved forwards until
the push-button is released.
Push the crown back into position I

(the display changes from reference time
to alarm time).
A 1 beep signal indicates that the alarm
is switched off.
Please note:
The reference time must display the same
time as the current time. This means that
resetting the current time also requires the
identical correction of the reference time.
Afterwards, the alarm time has to be reset.

Chronograph: Basic function

(Start / Stop / Reset)
Sekund
Alarm
(Stund
Sekund
Datum
01
Mult
Im Kali
Alle Fu
Ausgan
– mit
– mit
Chrono
Sobald
für den
Nachde
sind, en
Währen
vorgen
02
07.11.2022 09:57:30 07.11.2022 09:57:30
D
D