EDIFIER S360DB Bedienungsanleitung Seite 7

LED indicator blinks in a breathing pattern: subwoofer is disconnected and enters into standby mode
LED indicator blinks rapidly: subwoofer enters into pairing mode
LED indicator is constantly lit: subwoofer is connected and operates normally
Blu-ray player, game consoles,
STB(Set Top Box) etc
The active satellite speaker has been paired with the subwoofer before leaving factory.
The wireless connection is supposed to resume automatically when both active satellite
speaker and subwoofer are powered on, and the red indicator will be constantly lit.
If the wireless connection fails to resume, please follow the steps below to complete
the pairing again.
1. Power on the subwoofer, the red indicator should blink in a breathing pattern, which
means no active wireless connection.
2. Press and hold the Pair button on back panel of subwoofer for 2 seconds to put it
into pairing mode. The red indicator will blink rapidly.
3. Press and hold the "Pair" button on back panel of active satellite speaker to put it
into pairing mode.
4. Wait until the red indicator on subwoofer is lit constantly. Then the pairing is done
and wireless connection is made.
Connection
L
6
English