Transport; Storage; Maintenance; Disposal And Recycling - HERKULES SH7300E Original Bedienungsanleitung

12. Transport

m Attention!
Disconnect the mains plug before transport.
To transport the log splitter, the splitting blade must be
moved all the way down. Tilt the splitter slightly with the
handle on the splitting column until the machine tilts
onto the wheels and can thus be moved away (fig. 11).

13. Storage

m Attention!
Disconnect the mains plug before transport.
Before storing the unit, move the splitting knife to the
lower position.
Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging.
Cover the power tool to protect it from dust or moisture.
Store the operating manual with the power tool.

14. Maintenance

Attention!
Disconnect the mains plug before carrying out any
maintenance work.
When do I change the oil?
First oil change after 50 operating hours, then every
500 operating hours.
Oil change (Fig. 12)
• Fully retract the splitting column.
• Place a container with at least 8 litres capacity under
the splitter.
• Release the oil dipstick (14).
• Open drain plug (12a) at the bottom of the oil tank so
that the oil can run out.
• Close the oil drain screw (12a) again.
• Fill with 3.5 l of new hydraulic oil using a clean fun-
nel.
• Screw the oil dipstick in again.
Dispose of the used oil properly at a local used oil
collection point. Dumping used oil in the soil or
mixing it with waste is prohibited.
We recommend oil from the HLP 32 range.
Splitter spar
The spar of the splitter must be lightly greased before
commissioning. This process must be repeated every
5 operating hours. Apply grease or spray oil lightly. The
spar must not run dry.
Hydraulic system
The hydraulic system is a closed system with an oil
tank, oil pump and control valve.
The factory-completed system must not be changed or
manipulated.
Check the oil level regularly.
An oil level that is too low will damage the oil pump
Regularly check hydraulic connections and screw con-
nections for leaks – retighten if necessary.
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Engine data - type plate
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Riving knife/riving spar guides, hydrau-
lic oil
* may not be included in the scope of delivery!

15. Disposal and recycling

Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 35