Technical Data - HERKULES SH7300E Original Bedienungsanleitung

Hydraulics
Never operate this device if there is a hydraulic fluid
hazard. Check for leaks in the hydraulics before using
the splitter. Make sure that the device and your work
area are clean and free from oil stains. Hydraulic fluid
can cause hazards as you may slip and fall, your hands
may slip when using the machine or there may be a
fire hazard.
Electrical safety
• Never operate this device in the presence of an elec-
trical hazard. Never operate an electrical device in
humid conditions.
• Never operate this device with an unsuitable power
cord or extension lead.
• Never operate this device unless you are connected
to a properly earthed outlet that provides power as
labelled and is protected by a fuse.
Mechanical hazards
Splitting wood causes particular mechanical hazards.
• Never operate this device unless you are wearing
proper protective gloves, steel-toed shoes and ap-
proved eye protection.
• Beware of fragments that may occur; avoid puncture
injuries and possible seizing of the device.
• Never try to split trunks that are too long or too small
and do not fit properly into the device.
• Never attempt to split trunks that contain nails, wire
or other objects.
• Clean up when working; accumulated split wood and
wood chippings can create a hazardous working
environment. Never continue working in a crowded
work environment where you can slip, trip or fall.
• Keep onlookers away from the device and never
allow unauthorised persons to operate the device.
Residual risks
The machine has been built according to the state-of-
the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Danger of injury for fingers and hands from the split-
ting tool in the event of improper guiding or support
of the wood.
• Injuries due to the workpiece being ejected at high
speed due to improper holding or guiding.
• Hazard due to electrical power with the use of im-
proper electrical connection cables.
• Dangers due to particular characteristics of the
wood (branches, uneven shape, etc.).
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Switch off the device and pull out the mains plug be-
fore carrying out any setting or maintenance work.
• Furthermore, despite all precautions having been met,
some non-obvious residual risks may still remain.
• Residual risks can be minimised if the "Safety infor-
mation" and the "Proper use" together with the oper-
ating manual as a whole are observed.
• Avoid accidental start-ups of the machine: The oper-
ating button may not be pressed when inserting the
plug in a socket.
• Keep your hands away from the work area, when the
machine is in operation.
• During splitting, the properties of the wood (e.g.
growths, trunk slices of irregular shape, etc.) can re-
sult in hazards like ejecting parts, splitter blocking,
and crushing.

6. Technical data

Motor V / Hz
Rated input P1
Power output P2
Operating mode
Engine speed rpm
-1
Dimensions L x W x H
Table height
Working height
Wood length min.- max.
Wood diameter min. - max.:
Power (t) Max.
Cylinder stroke
Forward speed
Return speed
Oil quantity
Weight approx.
Technical changes reserved!
Noise
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
230 V / 50 Hz
3000 W
2200 W
S6 40%
2800
850 x 915 x 1495 mm
800 mm
920 mm
250 - 550 mm
100 - 300 mm
7
495 mm
4.5 cm/s
16.5 cm/s
3.5 l
98.5 kg
GB | 31