infinite spa CHAMPION 6 places Bedienungsanleitung Seite 58

4
Operation
Press this button and the filter pump will begin to operate. The red indicator light will illuminate. Press this button again and the system will
stop working and the light will go out.
The filter pump does not switch off automatically. If the water temperature falls below the pre-set temperature, the heating system switches
on again. If the heating system does not switch on automatically, switch the heating off and the filter automatically switches off after 2 minu-
tes, which prevents dirt from clogging in the system.
On/off button for the air jet system
Press this button and the air jet system starts working and the red indicator LED lights up. The jet system stops automatically
after 20 minutes. If you still want to use the jet system, you have to wait 10 minutes before you can press the "BUBBLE"
button again.
Button for setting the temperature
The current water temperature is indicated on the display.
When you press the TEMPERATURE button, the numbers on the display will start to flash.
To adjust the temperature, press the corresponding arrow button.
. Button for increasing the temperature
Button for decreasing the temperature
The temperature can be adjusted within the range 20–40 ° C
When you have adjusted the temperature, press the TEMPERATURE button again to confirm the new setting.
The current water temperature is now indicated on the display.
Note: It may take between 12 and 24 hours before the water has heated up to the required temperature. The ambient temperature and the
temperature of the mains water affect how long it takes for the water to heat up. The water temperature drops every time the heater is swit-
ched off on the SPA. So wait some time for the water to warm up before using the SPA next time.
On / Off button for the heating system
Press this button and the heating system starts working and the red indicator LED lights up. At the same time, the red light of the Filter button
lights and the filter pump starts working. This is normal because heating is not possible without the filter pump.
When the pre-set temperature has been reached, the heating system stops working, while the heating indicator light stays on.
The filter pump does not switch off automatically. If the water temperature falls below the pre-set temperature, the heating system switches
on again. If the heating system does not switch on automatically, switch the heating off and the filter automatically switches off after 2 minu-
tes, which prevents dirt from clogging in the system.
Important! Always install the cover on the spa after use to minimize heat loss when heating the water. For good heat insulation, make sure
that the cover is firmly in place. If the cover is not needed, it is recommended that you keep it off the ground in order to avoid contamination..
Store the cover in a suitable place where it cannot be damaged or cause damage
Note: The integrated temperature sensor works with an accuracy of +/- 2°C. Depending on the set water temperature, it may therefore be
the case that the heater / pump does not switch on immediately but with a delay. This is not a malfunction.
Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 58 Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 58 23.11.21 18:10 23.11.21 18:10