Inhaltsverzeichnis
Werbung
3. SET UP AND INSTALLATION
When the table has been assembled (see assembly instructions
installed so that the table is level and does not shift. Then the table is connected to the 100-240 VAC outlet
and the table is ready for use.
-
Make sure that no cables can get jammed.
-
Place the table in a safe distance from window frames, radiators, furniture etc. so that people do not get
stuck.
-
Do not place any objects above 55 cm underneath the table.
-
When moving the table after it has been assembled, the table top needs to be removed. The table CANNOT
be lifted by the table top. The desk need to be lowered to minimum height before moving.
-
Check package contents for completeness or damage before assembly.
-
Check the product surface and cables for obvious damage, do not install or operate products if damaged.
-
Make sure the product is not connected to a power source during assembly.
-
Ensure that there are no unnecessary obstacles near the assembly area.
-
Ensure that personnel with limited capacity to respond to hazards are not involved in the assembly process.
-
Children are not allowed to participate in the assembly process to avoid accidentally eating the installed
components.
-
Do not immerse any components in liquid and clean only with a dry or slightly damp cloth.
-
Do not place any cables under continuous heating places.
-
Be careful not to trip over the cable and to prevent entanglement (Between cables and cables, between
cables and people)
-
Please be careful to avoid electric shock when plugging in.
4. OPERATION
UP/DOWN operation:
Push "Up" button to move table up and "Down" button to move table down.
RESET
See page
.
MAINTENANCE AND DEFECTS
-
The table does not require any maintenance by usage as described in chapter 2 in the directions for use.
-
The table is only to be maintained with a damp cloth.
-
In the event of the occurrence of jarring sounds during operation, STOP using the table.
7. TECHNICAL DATA
Frame, materials:
Tabletop material:
Weights:
Width:
Depth:
Height:
V(speed):
Duty cycle:
Operation:
Voltage:
Standby consumption:
Max. working load:
PARTS
See page 86-88 .
ASSEMBLY DIRECTIONS
See page
-
.
Steel, powder lacquered
Particle board with melamine
31kg
160cm
80cm
70-118.5cm
~25mm/sec. -depends on load
10%, Max. 2 min. opreate. Min. 18 min. stop
Micro switches
100-240VAC | 50/60Hz
<0,15 Watt
40kg
UP button
4/100
) the adjustable feet are
DOWN botton
Werbung
Inhaltsverzeichnis
