Scantronic Secureconnect; Proximity Tags; Internal Radio Sounders; External Sirens - Scantronic i-on30R+ Benutzerhandbuch

Perimeter PIR detector – to
monitor external areas such
as gardens. Dual-sensor
technology and pet-tolerant
mode ensure reliable
outside operation.
Note: Other detectors are available –
please contact your installer for details.
Note: Since there is normally only one
detector per zone, the terms "zone" and
"detector" are often used interchangeably.

Scantronic SecureConnect™

The SecureConnect app allows
you to monitor and control
your alarm system over the
internet from your phone or
tablet.
Medical/social care transmitters

Proximity tags

Each user can have a unique
proximity tag. When presented to a
keypad, the tag performs the same
action as entering an access code.
Proximity tags make it easier for you to set
or unset the system, and there is no need
to remember an access code.

Remote controls

Each user can have a
portable remote control to
set or unset the system or
operate output devices from
a distance.
These pendants
and wrist-worn
transmitters
allow the wearer
to signal that
medical or social-
care assistance is
needed.

Internal radio sounders

These are intended for use
in areas that are out of
audio range of a keypad
but where you need to
hear alarms, entry tones,
exit tones and other
sounds.

External sirens

These are mounted
externally, high up in
a visible location for
deterrence. They include
a powerful sounder and
strobes. Wired and radio
sirens are available.
Several radio sirens can
be used for strategic
placement around your
property.

Network cameras

Internal and external network cameras are
available. These allow the control unit to
record images when an alarm occurs.
You can view the images through
the system log, including via the
SecureConnect app. SecureConnect can
also send images automatically to an email
address when an alarm occurs.

Hold-up alarm transmitters

Small portable
Hold-Up Alarm (HUA)
transmitters, also
known as Panic Alarms
(PAs), allow you to start
a hold-up alarm from
anywhere in range of
your control unit.

Output devices

Your installer can set up your alarm system
to switch external devices, such as lights or
heating systems, on or off.
Devices can switch on or off automatically,
such as when the system is set or when
an alarm occurs. Alternatively, you can
Page 5