Taking Out Of Operation; Cleaning / Maintenance / Repair - EINHELL PS 1002 NIRO Betriebsanleitung

GB
Ignition
Open the gas bottle valve.
Turn the button 90° anti-clockwise from „closed" position. Then press the button and ignite the burner by
actuating the piezo igniter.
Keep the button pressed for approx. 10 seconds after ignition until the burner remains on.
If the flame goes out you must wait at least two minutes before making a second attempt at ignition.
You can turn the button from the symbol of the small flame (low setting) to the symbol of the large flame (high
setting) according to your requirements. Infinitely adjustable setting of the heat output is also possible between
these two settings.
Closed High Low

Taking out of operation

To turn off the radiator, move the button to „closed" position and close the gas bottle valve.

7. Cleaning / Maintenance / Repair

7.1 Cleaning / Maintenance
The party radiator is best cleaned with special stainless steel cleaning agents. A weak alkaline solution can be
used for minor cleaning jobs. Under no circumstances are you to use preparations containing salt, sulfur,
chlorine or abrasive. Avoid contact with rusting objects - use foil, a piece of carpet or similar to protect the gas
bottle and base from such contact.
The party radiator can be cleaned with all standard, non-abrasive and incombustible liquids.
Be sure to turn off the radiator and allow it to cool before commencing with the cleaning.
Caution! Never clean the radiator with pressurized water (using a water hose, steam jet or high pressure)!
7.2 Repair
Have only approved gas fitters carry out repairs and maintenance work on the party radiator.
9