Repeater Mode; Getting Started Via Wps (Wifi Protected Setup); Getting Started Via Wlan Connection With The Pc - Hama 00053311 Bedienungsanleitung

B) Access point mode:
The repeater is connected with cables to your existing
network and, once successfully configured, sets up its
own independent wireless LAN.

6.2 Repeater mode

6.2.1 Getting started via WPS (WiFi protected setup)

Requirements:
To be able to use WPS, your existing WLAN router must
support configuration via WPS. Your WLAN router must
also use the WLAN encryption standard WPA or WPA2,
and the SSID (WLAN network name) of the WLAN router
must be set to visible.
Note
Please be aware that some manufacturers use different
terms instead of WPS. For further information, read
your WLAN router's operating instructions to determine
whether and how you can activate pairing via the
hardware button (WPS) on your WLAN router.
To set up the Hama repeater via WPS, proceed
as follows:
• Connect the device to a properly installed socket.
• Plug the Hama repeater close (we recommend using the
same room as the one that your WLAN router is already
in for initial setup) to the WLAN router and wait until its
status LED (4) lights up.
• Press and hold the WPS button (3) for around 2 seconds.
The status LED (4) starts to flash quickly.
• Press the WPS or QSS button on your WLAN router within
2 minutes, in accordance with the instructions in your
WLAN router's operating manual. (Please see your WLAN
router's operating manual to determine how long you
need to keep the button pressed for).
• Wait for around 3 minutes until the connection between
the WLAN router and the repeater has been set up.
• The connection has been successfully established once
the status LED (4) lights up permanently.
• Now position the Hama repeater in your desired location.
4
This completes the connection via WPS process and a
secure connection has been set up between the repeater
and the WLAN router.
6.2.2 Getting started via WLAN connection with
the PC
• Connect the device to a properly installed socket.
• Plug the Hama repeater close (we recommend using the
same room as the one that your WLAN router is already
in for initial setup) to the WLAN router and wait until its
status LED (4) lights up.
• Connect your computer to the "Wireless-N" network. You
do not need to enter a password.
• Then call up the address http://ap.setup in your web
browser. (Alternatively you can also call up the repeater's
IP address 192.168.10.1).
• Select a language and enter the password. Then click
"Login" to start the configuration process. The default
password is admin.
• Select "Wizard".
• Then select "Repeater".
• The repeater lists all available networks. Select the
desired network and enter the password for your
network. Then click Connect. You can change the router's
SSID if you wish. We recommend using the same SSID
that your WLAN network uses, however.
• After clicking "Connect", the repeater restarts. You now
need to connect your computer to the new network.
• Alternatively, you can also configure the repeater using
a network cable. To do this, connect your computer and
the repeater by means of a network cable. You can then
continue with the configuration process described above
from "Then call up the address http://ap.setup....".