System Requirements; Controls And Displays; On/Off Switch; Network Port - Hama 00053311 Bedienungsanleitung

4. System requirements

Please be aware that your computer or wireless device
must have either a WLAN network card / USB stick or
an integrated network adapter with an RJ45 LAN port.

5. Controls and displays

5.1 On/Off switch

Pressing the On/Off switch (1) switches the device on or off.

5.2 Network port

You can connect your PC or console to this network port if
you want this device to have access to your WLAN network
device.

5.3 WPS button

This button can be used both to connect / pair the repeater
with your WLAN router via WPS and for resetting the
repeater to its factory state if a malfunction has occurred.
For connection / pairing via WPS, read the section entitled
Getting started via WPS.

Restoring factory settings:

If the connection to the configuration program cannot
be established, reset the device to its factory settings by
pressing the WPS button for around 6 seconds.

5.4 LED display

The housing has a control symbol which, by virtue of
its flashing and illumination behaviour, indicates the
connection status within your network. The figure below
shows the meaning of the symbols.
Status LED
Constant light
Off
Flashing slowly
Flashing quickly
Repeater is switched on
Repeater is switched off
Repeater is not connected
to a network
Repeater is currently connecting to a
network

5.5 Default parameters

URL: http://ap.setup
IP address: 192.168.10.1
Password: admin
SSID: Wireless-N
Wifi key: None / No key required for connection

6. Getting started

Warning
• Only operate the product from a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• Disconnect the product from the power supply using
the On/Off switch – if this is not available, unplug the
power cord from the socket.
• If using a multi-socket power strip, make sure that
the total power consumption of all connected
devices does not exceed the power strip's maximum
throughput rating.
• If you will not be using the product for a prolonged
period, disconnect it from mains power.

6.1 Operating modes

The repeater essentially supports two different operating
modes:
A) Repeater mode:
The repeater amplifies your existing wireless LAN by
connecting it via WLAN to the existing router / access
point. Your existing network's SSID and password are
copied for this.
3